Welcome New Yankee Workshop Fans!  
Welcome New Yankee Workshop Fans!Welcome New Yankee Workshop Fans! Welcome New Yankee Workshop Fans!Welcome New Yankee Workshop Fans!
Welcome New Yankee Workshop Fans!














 April 4, 2012
Norm's Tricks Of The Trade

David: Question: I'd like to remove a door, but three of the hinge screws simply spin in place when I try to unscrew them. Is there a trick to getting out?
Don Morse of Cranston, R.I.

Norm's Answer: First remove any screw that will come out the usual way. Then gently pry or pull on the hinge leaf to pull out the stripped screws a bit. Now when you push the hinge back into place, the head of those stripped screws will stand out just enough for you to grab them with a pair of pliers, as shown. Pull each one out with a firm tug.
If the screws are still in good condition, with intact threads, remove any debris with a wire brush and reuse them.

It you plan to remount the door, you'll need to fill the stripped screw holes first. Whittle some small pieces of wood, put a dab of yellow carpenter's glue in the hole, and pack it full with the wood pieces. After the glue dries, trim off the excess bits of wood and you'll have solid material for the screw threads to bite into.

Photobucket